Sub-Engineer Mock Test of 50 Past Question #56

1. The compressive strength of concrete M25 under bending compression is

2. In R.C.C., steel is used because it can provide

3. Distribution reinforcement in a simply supported slab is provided to distribute

4. According to thumb rule, the thickness of a slab should be taken at the rate of

5. In a combined footing if shear stress exceeds 5kg / cm²  the nominal stirrups provided are:

6. In a beam section, if the steel reinforcement is of such a magnitude that the permissible stresses in concrete and steel are developed simultaneously, the section is known as

7. The section in which concrete is not fully stressed to its permissible value when stress in steel reaches its maximum value, is called

8. The minimum amount of bottom reinforcement that should be continued over the centre length of the beam in R. C. C. continuous beam is

9. Steel is efficiently used in

10. The total number of grades of concrete mixes as per IS 456 is

11. An expansion joints is provided when the length of a concrete structure exceeds

12. The test conducted by Vicat’s apparatus is for

13. The bulking of aggregate is

14. The capacity of waste water treatment plant located at Guheswori, Kathmandu

15. Sewerage system originates from

16. Per capita water demand is measured as

17. Pathogens in water may cause

18. If the coliform bacteria is present in a sample of water, then the coliform test to be conducted is

19. Water-shed line is abandoned for aligning an irrigation canal if

20. For a given discharge in a channel, Blench curves give the relationship between the loss of head (HL) and

21. Pick up the incorrect statement from the following

22. The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as

23. The walls which are necessary on the hill side of roadway where earth has to be retained from slipping is known as

24. The minimum design speed for hairpin bends in hill roads is taken as

25. Which of the following premix methods is used for base course?

26. Most suitable material for highway embankments is

27. The binder normally used in flexible pavement construction is

28. A muster roll is

29. Slack time in PERT analysis

30. Amount required to be deposited by contractor while submitting tender is

31. Total station is

32. Different grades are jointed together by

33. The angle of intersection of a curve in the angle between

34. The size of plane table is

35. The following sights are take on a ‘turning point”

36. A mortar joint in masonry which is normal to the face of wall is known as

37. The slenderness ratio for masonry walls should not be more than

38. The proportions of lime and sand in the mortar normally used in brick construction are

39. Dado is usually provided in

40. The process of making the back ground rough, before plastering is

41. Black cotton soil is unsuitable for foundations because its

42. The exterior angle between outer faces of a wall, is known as

43. A projecting piece usually provided to support a truss, is

44. Which of the following tests measures the toughness of road aggregates?

45. Reconnaissance is best done with the help of

46. The distance travelled by revolving the wheel of a vehicle more than its circumferential movement, is known as

47. The coefficient of compressibility of soil, is the ratio of

48. The ratio of volume of air voids to the volume of total voids, is known as

49. In the time-cost optimisation, using CPM method for network analysis, the crashing of the activities along the critical path is done starting with the activity having

50. Time and progress chart of a construction, is also known as