Sub-Engineer Mock Test of 50 Past Question #73

1. The sum of amount required to be deposited by a contractor while submitting a tender is known as

2. Which is not a part of rate analysis?

3. Total length of CGI sheet in bundle is:

4. The main factor to be considered while preparing a detailed cost estimate is:

5. The main factor to be considered while preparing a detailed cost estimate is:

6. Reciprocating pumps are suitable for:

7. Bulking of sand is maximum if moisture content is about:

8. Minimum water-cement ratio required for a workable concrete is:

9. The angular steps for changing direction of the stairs are known as:

10. For a most economical trapezoidal channel section:

11. Based on the span, trail bridges are categorized into …….categories.

12. Which one is not the component of the rural gravity water supply system?

13. A wall-constructed to retain the earth from slippage on hillside of a roadway is called:

14. The end supports of a bridge super structure are called:

15. According to the functional classification of road as specified in the Nepal Road Standard 2070, roads are classified into….. categories.

16. The internal angle of a regular hexagon is:

17. How many fundamental rights are mentioned in present constitution of Nepal?

18. According to the Local Government Operation Act 2074, a person or government office who has been given permission to construct a building from the local level should complete the construction of the building within:

19. The second part of present constitution of Nepal deals about:

20. The specific gravity of cement is about:

21. Which paints are most resistant to fire?

22. Quartzite is a:

23. An aggregate is said to be flaky if its least dimension is less than……..

24. The liquid part of the paint is called:

25. After storage for long time, the strength of cement:

26. The function of plasticizer admixture in concrete is:

27. The preparation of surface of stones to obtain plain edges or to obtain stone of required shape and size is known as:

28. Which one is the enlarging scale in scale of drawing?

29. Lines which are continuous thin lines and are drawn at an angle of Forty five degree to the main outline of the section is called:

30. The formwork for the sides of beams can be removed only after:

31. The modular ratio for design purposed of M20 concrete is taken as:

32. A masonry wall of a room can be made earthquake resistant by providing:

33. Long Span Trail Bridge (LSTB) required norms standards and technologies to design both D & N type bridge having length:

34. The function of launching apron in River Training is:

35. A fittings used to connect the service pipelines with the water main is called:

36. If the whole circle bearing of a line is 180° its reduced bearing is:

37. A total station measures vertical angle of 45° from a point on land to the top of a pole that lies 30m far. The height of the pole is:

38. Isogonic lines are the lines having the same value of:

39. The slump test of two samples of concrete shows slump value of 50mm and 100mm. Choose the correct statement

40. According to national drinking water quality standard of Nepal, the turbidity value of drinking water should be between:

41. Which device is used to protect the wiring form short circuit fault?

42. The detention period of a Septic Tank is:

43. Reciprocal ranging is adopted when which of the following is encountered during surveying?

44. Closing error can also be known as

45. The bearings of the lines AB and BC are 130° and 50° respectively. The included angle ABC is:

46. The technique of findings the fair market price of an existing property at specified point of time is known as:

47. Brick walls are measured in square meter if the thickness of the wall is:

48. Standard size of Drawing Board D1 is:

49. The actual length of a line in field and the drawing are 100 meters and 5cm respectively. Find the scale of drawing:

50. If top, front and side views of an object are circular, the object is,