Sub-Engineer Mock Test of 50 Past Question #51

1. The head light of vehicles should be such that its lower beam illuminates objects at

2. The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as

3. Which of the following bricks are used for lining of furnaces?

4. Which of the following canal structures is used to remove surplus water from an irrigation channel into a natural drain?

5. The best process of disinfection of public water supply, is by

6. When gravity and pumping systems of water distribution are adopted, the type of distribution reservoir, is

7. Permanent hardness of water can be removed by

8. In chain surveying, perpendiculars to the chain line are set out by

9. In an adjusted level, when the bubble is central, the axis of the bubble tube becomes parallel to

10. In a combined footing if shear stress does not exceed 5 kg/cm² , the nominal stirrups provided are

11. Dimensions of a beam need be changed if the shear stress is more than

12. Which of the following excavators is most suitable for digging under water?

13. For ventilation the total area of window opening of a residential building should be:

14. Architectural modelling is used for:

15. Vertical presentation of comparative value is shown by:

16. Topography is the most critical criterion when routing which of the following utility lines:

17. The practice of balancing cut and fill is used in:

18. Over consolidated soils caused due to:

19. A generic software engineering design follows:

20. The minimum height of the building (from floor to ceiling) should be:

21. Coolest area of a building is:

22. The terms ‘scratch coat’, ‘brown coat’ and ‘finish coat’ refer to:

23. On a given site, which of the following would not be relevant to life cycle costing?

24. The shape of building, as far as possible should be kept:

25. The structural walls in a building in brick masonry in cement mortar should have the minimum thickness of:

26. Transport of concrete by pumps, is done for a distance of:

27. The bulk density of aggregates, depends upon:

28. If an element is subjected to pure shearing stress rxy then the maximum principal stress is equal to:

29. A steel cable of 2cm diameter is used to lift a load of 500kg. Given that, E=2×10kg/cm² and the length of the cable is 10m, the elongation of the cable due to the load will be:

30. A T-section is used as a simply supported beam with uniform loading. The maximum bending stress for a given load will occur at the:

31. The maximum energy stored at elastic limit of a material is called:

32. In particular materials, if the modulus of rigidity is equal to the bulk modulus the poisons ratio will be:

33. Which of the following is paint thinner?

34. The rocks with volcanic origin are:

35. Which type of chain is mainly used for measuring fields in cadastral survey?

36. A staff reading taken on bench mark is:

37. A line drawn through the plotted location of the sighted station the instrument station in plane tabling survey is called:

38. The coefficient of permeability of soils, is generally expressed in:

39. The unit of resistivity is:

40. A street sewer, into which sewer from house connections pours, is called:

41. Estimate of electrical service is made in:

42. The length of septic tank should be:

43. The function of management is/are:

44. The feasibility report of a project is prepared:

45. The time corresponding to minimum total project cost is called:

46. The main disadvantage of bar chart is:

47. The first method invented for planning projects, was:

48. The surface area for both side painting of fully glazed window is estimated as one window surface area multiplied by:

49. In valuation the value of property decided is:

50. The volume of coarse aggregate required to make 100m² of 1:2:4 concrete is: