Sub-Engineer Mock Test of 50 Past Question #50

1. In direct method of contouring, the process of locating or identifying points lying on a contour is called

2. Revolving of the telescope of a theodolite in a horizontal plane is:

3. Which of the following is generally not used in a plane tabling survey?

4. The method of plane tabling generally adopted to obtain details and plotting inaccessible points is:

5. Reciprocal ranging is adopted when the following is encountered:

6. ………is used for most accurate measurement.

7. An ordinary Portland cement bag weights:

8. Bitumen paint renders:

9. Which of the following has the highest crushing strength?

10. Water required per bag of cement, is

11. A structural with multiple straight and linear members, and all the joints pin joints is a:

12. The shape of a bending moment diagram of a beam carrying a uniformly distributed load is:

13. Centre of gravity of a thin hollow cone lies on the axis of symmetry at a height of:

14. When shear force at a point is zero then bending moment at that point will be:

15. For walls, columns and vertical faces of all structural members, the form work is generally removed after:

16. For exerting a pressure of 4.8kg / c m²  the depth of it specific gravity 0.8, should be:

17. The velocity of the fluid particle at the centre of the pipe section is:

18. Which of the following is a glacial soil:

19. A foundation is called shallow, if its depth, is:

20. Failure of the stability of slope generally occurs along:

21. Cohesive soils:

22. Tensile internal force tends to:

23. The property of fresh concrete, in which the water in the mix tends to rise to surface while placing and compacting is called:

24. M25 grade of concrete approximates:

25. Slump test is concrete is used for:

26. The breaking up of cohesions in a mass of concrete is called:

27. Seasoning of timber is required to remove

28. The most important tool is brick laying for lifting and spreading mortar and for joints is:

29. The overlapping of bricks or stones in masonry is called:

30. It is estimated that the quantity ratio of water supply is Kathmandu by exploring ‘ground water’ to that by utilizing ‘Surface runoff’ water (GW:SW) is:

31. The capacity of flushing cistern for water closets is:

32. Turbidity is mainly due to:

33. The maximum pressure to which cast iron pipes may be subjected to is:

34. Kharif crops are grown is:

35. When Koshi river (Koshi development) is signed:

36. Hydrograph is the graphical representation of:

37. Rails are fixed on steel sleepers:

38. The slope provided to the road surface in the traverse direction to drain off rain water is best termed as:

39. In WBM roads the binding medium is………..

40. The rate of rise or fall the road surface along its length, is called

41. In bitumen bound macadam roads a bituminous premix at the following is temperature is applied:

42. The surface area for both sided of painting of fully glazed window is estimated as ‘one side window surface’ multiplied by:

43. While analyzing the rates, generally the contractor’s profit and overhead is added at the rate of:

44. The method of valuation of a building as used by commercial banks, is based on:

45. The estimated time required to perform an activity, is known as:

46. The amount of money paid to the contractor by the client after the agreement and before the execution of work is known as:

47. Site order book is used for recording:

48. The height of the pilot’s eye above the runway surface is assumed:

49. For night landing, the thresholds are lighted:

50. The final operation of finishing floors, is known as