Sub-Engineer Mock Test of 50 Past Question #42

1. In surveying when curvature of earth is taken into consideration then that type is called as

2. In a reinforced concrete column, the minimum cover to longitudinal reinforcement shall neither be less than the diameter of the bar nor less than:

3. The grade of concrete generally not used in reinforced concrete structure is:

4. Two layers of tensile reinforcement bars are put in a flexural members in such a way that the effective depth would be:

5. Shear force in a concrete beam is assumed to act:

6. Transverse reinforcements in a reinforce concrete beam are mainly to resist:

7. Tensile internal force tends to:

8. Brittle failure of a reinforced concrete beam mostly indicates that the beam is having:

9. The earliest period for removing formwork from the RCC slab of a span up to 4:0m under normal atmospheric condition should be :

10. Which of the following is not an activity associated with damp proofing?

11. Which of the following is not a tool used in laying a brick wall?

12. Which of the foundation is likely to be adopted for a 3 floors high RCC framed residential building?

13. Source of water in the mountain is:

14. The physical characteristic of sewage is:

15. The daily water demand per capita is taken as:

16. The sludge does not contain waste water from:

17. Manning’s rigidity coefficient is expressed in the unit:

18. In irrigation canals drops are needed, if:

19. The inward tilt or transverse inclination given to the cross section of a carriageway on a horizontal curve to reduced the effects of centrifugal force on a moving vehicle is known as:

20. The areas from which rainfall flows into a drainage line, outfall or reservoir is known as:

21. In a road structure, the layer immediately under the surface course is called a:

22. Allowable axle load in a timber bridge with 50mm planks supported on stringers at 600 mm interval is:

23. Carpet area of a building does not include the area of:

24. For estimating painting area for iron grillwork over a door or window opening the area measured will be :

25. For concreting is 1:2:4 cement concrete mix for the floor of a building with floor area equal to 100 sq. meter with thickness of 100 mm, the volume of cement required will be :

26. The dispute in construction is resolved through discussion of all parties on their respective stands leading to the consensus. The process is called:

27. In critical path method CPM, the actual performance of task is called:

28. The dummy activity in CPM:

29. Bottom most layer of a pavement is called:

30. The highest point on road surface is called:

31. The basic head loss in a long pipe is due to:

32. The unit of kinematic viscosity is:

33. Shear stress on principal planes is

34. Contour line is a line that connects points of equal:

35. Which of following instruments is used best for the measurement of a vertical angle?

36. What should be the actual; plot area for a land measuring 2.5×4.0 cm in a cadastral map  drawn at a scale of 1:500?

37. The age of tree can be known by examining:

38. The main ingredients of Portland cement are:

39. The displacement of natural axis of the beam under the transverse load is:

40. The strain energy stored in a specimen when strained within the elastic limit is:

41. Practical fluids possess:

42. To measure very low pressure, we use :

43. The upper surface of the weir over which water flows is known as:

44. In flow, the liquid particles may possess :

45. Cohesion less soils are formed due to:

46. Co-efficient of curvature for a well graded soil is between:

47. The ratio of volume of voids to the total volume of the given soil mass is known as:

48. For a two-hinged arch, if one of the supports settles down vertically, then the horizontal

49. The deformation of a spring produced by a unit load is called

50. The cavitation occurs in the pipe when the pressure is