Sub-Engineer Mock Test of 50 Past Question #37

1. Water is open channel and streams measured through:

2. The hydromantic force exerted by 2m deep water on the gate down stream is equal to:

3. The discharge in open channel is inversely proportional to:

4. Cohesion is defined as:

5. Type of foundation are:

6. The strength of a soil is usually identified by:

7. The soil transported by wind and deposited is called:

8. The maximum water content of a saturated soil at which a reduction in its moisture does not cause a decrease in volume of soil is called:

9. Lap in bars are equal to:

10. The amount of reinforcement for main bars in a slab is based upon:

11. The minimum size (diameter) of the longitudinal bars in the column should be:

12. A column is considered as a long column if its slenderness ratio is more than:

13. A type of bond into a brick masonry consisting of alternative course of header and stretcher is called:

14. Damp proofing is done:

15. The wooden piece joining the bottom ends of the rafters is:

16. A type of flooring made with special aggregate of marble chips mixed with white and coloured cement, is called:

17. Disinfection of drinking water is done to remove:

18. Runoff is the quantity of water which flows:

19. The underground structure in the form of circular or rectangular tank for the purpose of admitting sewerage into it from the intercepting chamber is called:

20. Self-cleaning velocity of sewer will be increased as:

21. The force exerted by flowing water on the sediment particles to course their motor is called:

22. Over irrigation result in:

23. Drop structures in canal is provided for :

24. In geometric design of highways the most controlling features are :

25. Which of the following is not true about highway drainage?

26. A water bound macadam road is an example of:

27. The minimum stopping sight distance for a trunk road on level terrain is:

28. Specification is the:

29. Which of the following is not considered while preparing item rate estimate?

30. The fundamental units is metric system are:

31. Plinth area estimate is an approximate estimate mostly used for the estimation of:

32. The tender is:

33. Types of organization used is construction industry is :

34. What are the key dates of a standard contracting procedure of a project?

35. The run way orientation is made so that landing and take off are:

36. A curve of varying radius is known as:

37. The theodolite is an instrument used for measuring accurately

38. A fixed point of known elevation above datum is:

39. An imaginary line joining points of equal elevation on earth surface is:

40. Fundamental principle of surveying is to work from the:

41. The ordinary cement used in general construction is:

42. The states of concrete are:

43. Excess of alumina in a brick earth causes:

44. State stone is a:

45. What type of paint do you recommend in doors on the exterior wall of a building?

46. Bending moment diagram of simply supported beam with a point load at the centre of the span is :

47. Stress may be defined as force per unit:

48. Factor of safety is defined as:

49. Fatigue is the failure of a material under:

50. The loss of head at entrance in a pipe is :