Sub-Engineer Mock Test of 50 Past Question #70

1. The part of the brick cut from a whole brick to maintain the bond in such a way that its one long face remains uncut is known as

2. The maximum height of masonry wall generally done in one day

3. For well graded soil, the coefficient of curvature will be between

4. For slopes of limited extent the surface of slippage, is usually along

5. The rate of rise and fall along the road alignment, is called

6. According to Nepal Road Standard 2070, the Right of way for feeder road is

7. A lined alluvial canal is best designed on the basis of:

8. The area under the beta- distribution curve is divided into two equal parts by:

9. The first method invented for planning projects was

10. Pick up the plutonic rock from the following:

11. German silver is an alloy of

12. What is the unit of measuring cornice ?

13. The expected out turn of half brick partition wall per mason per day is

14. If the specific gravity of oil is 0.7, then the density of oil is

15. When the flow parameters at any given instant remain same at every point, then flow is said to be

16. Fundamental relationship between dry density (γd), bulk density (γ) and water content (ω), is :

17. The internal molecular attraction of a soil, the cohesion

18. Minimum number of bar in rectangular column is

19. An under-reinforced section means

20. The valve provided at summit of pipe is

21. Water losses in water supply, is assumed as

22. To give a brilliant finish, the type of varnish used is

23. The R.L of banch mark is 1000.0 m and back sight reading at the bench mark is 2.555m find the staff reading of IS is RL of IS is 1000.055 m

24. The fuel generally used for burning limestone is

25. The Young’s modulus of a material is 125 Gpa and Poissons ratio is 0.25. The modulus of rigidity of the material is

26. Design of R.C.C. simply supported beams carrying U.D.L. is based on the resultant B.M. at

27. The phenomenon by virtue of which the cement does not undergo large change in volume when treated with water, is known as

28. The maximum permissible chlorine content for public supplies should be between

29. In a rapid sand filter, the filter head varies from

30. The narrow strip of land left at the ground level between the inner toe of the bank and top edge of the cutting, is known as

31. A device which ensures a constant discharge of water passing from one channel to another irrespective of water level in each within certain specified limits, is called

32. The total length of a cranked bar through a distance (d) at 45? in case of a beam of effective length L, is

33. The difference between the time avail-to do a job and the time required to do the job, is known as

34. A flow through an expanding tube at constant rate is called

35. Excess of silica in brick earth causes

36. The modular ratio for the design purposed of M20 concrete is taken as

37. The work of in which bricks are left projecting out in a masonry wall is known as

38. Los Angeles testing machine is used to conduct

39. A deflecting groyne in a river is

40. Ridge canal is also known as

41. The valves which allow water to flow in one direction but prevent its flow in their reverse direction.

42. Which one of the following does not require treatment before its disposal

43. Cross hairs in surveying telescopes, are fitted

44. Intensity of forces distributed over given section is called

45. Flash set of concrete is due to

46. The maximum no. of steps in a flight of stair case should generally be restricted to

47. A volatile substance added to a paint to make its application easy and smooth is known as

48. The shear stress distribution over a rectangular cross section of a beam follows

49. The minimum and maximum diameter of sewers, generally adopted in design may be

50. The unit of measurement is per quintal for the following: