Sub-Engineer Mock Test of 50 Past Question #53

1. Moment of inertia of an object having rectangular section of ‘b’ as width and ‘d’ as depth is given by:

2. Stone aggregates are said to be flaky if its’ least dimension is less than the mean dimension by:

3. Garret diagram was invented for the sake of

4. If area is in m² and the length is also in m, then the moment of inertia is expressed as:

5. The lateral earth pressure exerted by the soil when the retaining wall moves away from the back fill is:

6. Construction of cavity wall is for the purpose of

7. The minimum reinforcement in either direction in slabs using mild steel should not be less than

8. Initial setting time of ordinary Portland cement is:

9. Fall in the canal bed is provided if:

10. In the design of pavement thickness using CBR method, CBR value is considered for penetration of

11. While plotting in a paper at a scale of 1:1000, a distance of 20 m in the field is equivalent to:

12. The velocity at which the solid without settling at the bottom particles will remain suspension of sewer is:

13. According IS system of classification of soil, silt has the size between

14. Land in only one side can be irrigated in case of:

15. Time required by rainwater to reach outlet of the drainage basin is known as:

16. Sale value at the end of estimated life of structure of an equipment without dismantling is:

17. In case of pipe flow, if diameter of pipe is increased and the other conditions remains same, head loss will:

18. The prime, objective of construction management is

19. Bottom most component of a flexible pavement is:

20. The earliest method used for planning of projects was

21. Specification specifies or describes

22. The order of booking the dimension is

23. Hair pin bend are frequently provided at

24. The portion of earth immediately beyond the carriageway edge is

25. Which is the eldest highway in Nepal?

26. Which of the following shapes is preferred in a valley curve?

27. Which of the following canal structures is used to remove surplus water from an irrigation channel into a natural drain?

28. The most efficient section of a channel is

29. The total length of tunnel from the intake to sundarijal of the melamchi water supply project is

30. As the diameter of sewer increases, the self-cleaning velocity

31. An ornamental projection from the face of a brick wall is called

32. From the point of view of maximum day light, the windows in a room should be located on

33. The total thickness of flat slab should not be more than

34. Airport runway is usually oriented in the

35. The foundation in which a cantilever beam is provided to join two footings is

36. A column is considered as a long column if its slenderness ratio is more than

37. According to Dracy’s law, the velocity of flow of water through soil is depends on

38. Soils containing organic matter

39. Which of following test is carried out in the field while doing site investigation?

40. The range of velocity in a pipe

41. The discharge over a broad crested weir is maximum when the depth of flow is

42. Bitumen is generally obtained from

43. Beaufort scale consists of

44. ABCD is a square, bearing of AB = 40°, Hence bearing of DC is

45. Which of the following instrument is generally used for base line measurements?

46. The contour line can cross one another on map only in the case of:

47. Flow through the valve is only in one direction in :

48. The proportions of lime and sand in the mortar normally used in brick construction are

49. Workability of concrete is inversely proportional to

50. The most accurate method for the determination of water content in the laboratory is