Sub-Engineer Mock Test of 50 Past Question #35

1. In a sanitary pipe line for 3m length, how many skilled labour are required:

2. In which of the following crops are in Rabbi groups ?

3. Which of the following is the manning’s formula:

4. The moment of inertia of square section is given by:

5. The maximum bending moment in simply supported beam UDL is applied:

6. In RCC works the proportion of the mixture 1:1.5:3 the volume of the cement is in 1m ^ 3:

7. The Darcy’s formula is given by:

8. Bearing capacity of soil primarily depends upon ;

9. The discharge passing through the pipe having length 1.25m, height of the flow water 0.25m and Cd= 0.035 is :

10. Airport elevation is the reduced level above MSL of:

11. The length of runway is increased per 300 m rise above M.S.L.

12. Maximum difference in elevation between the highest and lowest point of the runway divided by the total length of runway is known as:

13. As per NWSC, the water supply for domestic demand is:

14. The distance between the top of the step & the hand railing is called:

15. The bitumen is used for:

16. The constituents of the cement are:

17. The loss of ingredient in cement should not contain:

18. The maximum permissible velocity in sanitary stoneware pipe is

19. The timber bridged is used where:

20. Manhole is provided at:

21. The soil having minimum bearing capacity is:

22. The control chart is used in construction works:

23. The lateral earth pressure of the soil moves towards the retaining wall indicates:

24. The highest point on the road is called:

25. The sanitary sewage obtained from bath & kitchen is called:

26. In the column, the minimum cover is provided at the end of reinforcement is:

27. The reinforcement is bent at an inclination of angle at the ends of the beam:

28. In Nepal, the generally used method of bond in masonry wall of brick work is:

29. Cavity wall:

30. DPC stands for:

31. A dam is:

32. A truss is completely analyzed, when:

33. A cable subjects to UDL over its entire span assumes a shape of

34. The CPM stands for:

35. The imaginary line joining the each head of water is called:

36. The property of the soil which allows to flow water through the soil is known as:

37. Traffic density is:

38. Chazy’s formula is given by:

39. When the canal runs below the drain, the cross drainage work provided is called:

40. The black cotton soil is:

41. The optimum moisture content in the compaction denotes:

42. Minimum Number of Piles needed to support a column ;

43. The wall constructed to resist the horizontal pressure is ;

44. Most of the shear test are done in equipment which are ;

45. Type Of Compaction for Congested area for all type of soil ;

46. Compaction is done to remove…….from soil

47. Standard proctor test is used to determining the ;

48. What happens after adding the water to cement ?

49. The WCB of line is 33842’, then quadrantal bearing is:

50. The oily liquid in which base and pigment are dissolved to form a paint is?