Sub-Engineer Mock Test of 50 Past Question #14

1. The principle of super position is valid only and only if the material, is

2. In a truss, the joints are considered to be

3. At free end of cantilever beam

4. In a cantilever beam, a moment M is applied at the free end yields slope at free end

5. Ratio of cement, sand and aggregate for M25, is

6. Spacing of shear stirrup is

7. Minimum lap for compression bars, is

8. Minimum percentage of steel in column, is

9. The main principle of survey is to work

10. The short offset is measured with

11. The angle between two plane mirrors of optical square

12. Accidental or compensating errors of length L are proportional to

13. Inner part of timber log surrounding the pitch, is called

14. The base material for distemper, is

15. According to ISI, bitumen is classified into

16. Maximum size of clay particle is

17. The ratio of the volume of voids to volume of solids in soil mass, is known as

18. A pycnometer is used to measure

19. During the seepage trough soil, direction of seepage is always

20. Design speed for class I road in plain terrain, is

21. The minimum shoulder width for road class II is

22. According to Nepal Road Standard 2070, the Right of way for feeder road is

23. Most suitable material for highway embankment is

24. The ductility value of bitumen for suitability in road construction should not be less than

25. The absolute minimum radius of horizontal curve for a design speed 60Km/hr is

26. In water bound macadam roads, binding material, is

27. The height of the Pilots eyes above the runway surface is assumed

28. The technique of finding the exact price of existing building or property is known as

29. The running bill is also known as

30. The unit of measurement of cornice is

31. The information which cannot be included in drawings is conveyed to estimator through

32. The first stages of construction project is

33. Site order book is for recording

34. The performance security of contractor is refunded after

35. Which is responsible for accident occurred at worksite

36. To measure very low pressure we, use

37. The upper surface of the weir over which water flows is known as

38. Falling drops of water becomes sphere due to

39. Cavitation is caused by

40. The ratios of volume of air voids to the volume of total voids is

41. A flow net may be utilized for the determination of

42. Accurate determination of water content, is made by

43. The bearing capacity of a soil depends upon

44. B.O.D. of treated water should be

45. The depth of rice root zone is

46. A river training work is generally required when the river is

47. The ultimate nearing capacity of soil, is

48. Minimum no. of pile require to support a column, is

49. The specific gravity of sand is approximately

50. Horizontal flow of water in soil is due to