Sub-Engineer Mock Test of 50 Past Question #107

1. The maximum particle size for which Darcy’s law is applicable is

2. For determining the velocity of flow of underground water, the most commonly used non-empirical formula is

3. W is the weight of soil having a moisture content ω. If V is the volume of proctor’s mould, the dry density of the soil is

4. The shear strength of a soil

5. For earth pressure at rest, there will be no

6. The solvent used in cut back bitumen is

7. Tar is not used now because of ………..

8. The allowable maximum water content in bitumen should not be more than

9. For general engineering purposes, soils are classified by

10. If you are asked to classify soils into 3 categories, which of the following categorizations would you prefer?

11. Snowcrete is one of the patent forms of

12. The bitumen surface becomes stiff in ………

13. If slenderness ratio for a column is 100 then the column is said to be

14. In specification of earth work in foundation trenches, specified lead is…………..

15. Functional organization system of working was introduced by……

16. A beam is said to be loaded is pure bending when………….

17. The inclined member carrying compressive load in case frames and trusses is…………….

18. A cantilever beam is one which is

19. The value of property that can be obtained at any particular time from the open market if the property is put for sale, is known as..

20. The width formation of a road means the width of……….

21. Most important source of water for public water supply, is

22. The joints provided in wooden floor are

23. Height of chimney of kiln is generally

24. Jhama bricks are

25. सचिव र मुख्य सचिवको पदलाई कस्तो प्रकारको पद भनिन्छ

26. वैज्ञानिक व्यवस्थापनका पिता भनेर कसलाई चिनिन्छ

27. नेपालको संविधानको अनुसूची ९ मा रहेको संघ, प्रदेश र स्थानीय तहको अधिकारको साझा सूचीमा कतिवटा अधिकारका विषयहरु रहेका छन् ?

28. चट्टान सम्वन्धी अध्ययन गर्ने विज्ञानलाई के भनिन्नछ?

29. The possibility of bleeding, segregation and laitance is reduced by

30. नेपालमा बजेट प्रणाली कहिलेदेखि शुरु भएको हो ?

31. As per latest approved government standards, what is the value if floor institutional building?

32. Canal loss is minimized by lining which cause

33. The thickness of slabs and beams must be measured to the nearest

34. Which of the following is not a method of plane table surveying?

35. During temporary adjustment of theodolite, parallax is remove by……

36. The building design may be influenced by

37. Which device is used for silt removal after it enters the canal?

38. At yield point of a test piece, the material

39. A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is

40. Traffic density depends upon the

41. The water that cannot be drained of by gravity is called

42. Span of bridge is more than

43. If a cement concrete road is properly constructed and maintained, then its expected life will be

44. The transition curve is useless when the radius of curve is

45. In a square beam loaded longitudinally, shear develops

46. The pile which is provided with a bulb filled with concrete at its lower end, is known as

47. The cross-sections for a highway is taken at

48. The assumption on which the trapezoidal formula for volumes is based, is

49. The total length of a cranked bar through a distance (d) at 45° in case of a beam of effective length L, is

50. What should be the actual area of the length measuring 2.5cm * 4cm (0.025m * 0.04m) in a cadastral map drawn at a scale of 1:500?