Sub-Engineer Mock Test of 50 Past Question #38

1. The amount of water required to fill up the pore spaces in soil particles by replacing all air held in pure space in known as:

2. If the wearing course of road is 5cm, base course is 15cm, sub base course is 15cm and capping layer is 15cm then what will be thickness of payment?

3. For transportation purposed in Nepal. the first preference is given to :

4. The maximum super-elevation on hill roads should not exceeds :

5. A wall constructed to retain the earth from slippage on the hill side of the roadway is called:

6. Specification of a construction work clearly defines:

7. The district rate finalizing committee does not include the representative of:

8. What is the maximum overhead added to the rate analysis?

9. An RCC element, 1m deep and 0.5m wide require minimum reinforcement @ 1% of gross sectional area, what will be area of reinforcing bars?

10. The first stage of a construction is:

11. The completion report includes:

12. Muster rolls are used for:

13. Which types of network was first develops for planning of any project:

14. Classification of Airport by ICAO is based on:

15. If an air traffic control tower is needed at the airport, it is usually located on the roof of:

16. Contour lines look to cross each other in case of:

17. The triangle formed by joining the position of the known points on plane table survey is known as:

18. An error is measured length due to the sag of chain or tape is known as:

19. In the scale of map is 1:25000 what it means:

20. You are requested to carry out a survey for the construction of a small airport in mountainous region of Nepal. Which of the following surveying method you will choose?

21. The fineness of cement is tested by:

22. Sand has minimum volume when:

23. The main constituents of Portland cement are:

24. The process of hardening the concrete by keeping its surface moist is known as:

25. Portion of the brick obtained by cutting a brick its length wise into two portion:

26. The ratio of change in volume to the original volume is called :

27. A continuous beam shall be deemed to be a deep beam if the ratio of effective span to overall depth, is

28. When a rectangular beam is loaded transversely the maximum compressive stress is developed on the:

29. Velocity of flow may be determined using

30. A vertical wall is subjected with a liquid pressure on its one side, the total pressure on the wall acts at a distance of…..from the liquid surface.

31. The discharge through a V notch weir is directly proportional to

32. Which of the following is not the purpose of a foundation?

33. Moisture content of saturated soil equal to:

34. Consolidation test of a soil sample is carried out to determine:

35. Bearing capacity of soils depends on:

36. Which type of soil you prefer for the filling of the runway of an airport?

37. In a singly reinforced beam (concrete) as the load increase:

38. A simply supported beam of span L carries a uniformly distributed load W. The maximum bending moment M is:

39. A column is defined as short if:

40. The wall constructed to resist horizontal pressure is:

41. The platform in which window rests on the wall is:

42. Which of the following is not true about a cavity wall?

43. Different types of bonds used in bricks masonry work due to:

44. For the design of water tank in a remote area of Nepal, how much domestic demand you consider?

45. The rate of flow in artisan spring is

46. It is practical to design sewer for the soft cleaning velocity at:

47. Baffle wall in septic tank is:

48. When designing the canals, manning’s formula’s generally used for

49. Maximum water required in case of paddy is at the time of:

50. Spillways are generally constructed for :