Sub-Engineer Mock Test of 50 Past Question #39

1. Coating the surface of steel by thin layer of zinc is called:

2. In a flowing fluid, a particle may possesses:

3. The unit of payment for damp-proof course (DPC) work is:

4. The total float for any activity along the critical path in critical path method (CPM) is:

5. According to Nepal Road Standard 2027 (first revision 2045) the design speed for feeder roads in rolling terrain is:

6. Type of paint whose main constituent is white or coloured cement and is used to protect plastered surfaces brickwork, masonry in damp places is called as:

7. Camber (cross-slope) prescribed for cement concrete or high type bituminous road surface is:

8. While manufacturing white cement, special care is taken to exclude iron-oxides which imparts:

9. Black cotton soil is not suitable for foundation because of its:

10. The strength of winds is measured with the help of:

11. The slenderness ratio for masonry walls should not be more than:

12. If a rod is simultaneously pulled at both of its ends, it will be a case of:

13. For a properly designed footing the bearing stress must be less than the bearing capacity, which is the bearing stress that causes, a ……..failure within the foundation soil

14. In case of a broad-crested weir the depth of water h at the end of still is given by:

15. Distemper is generally used in:

16. Contour line equally spaced represent a:

17. When maximum stresses in concrete and steel reach their permissible stress at the same time, then the section is called  as:

18. The circular isolated depression formed on a flexible road is known as:

19. The process of keeping concrete moist for several days after finishing is called

20. The compaction due to long term static load and resulting expulsion of water is called:

21. Finely powdered burnt clay is called:

22. The term CPM in construction management is an abbreviation of:

23. Angle of internal friction is minimum for:

24. The highest overall speed at which a driver can travel under prevailing conditions without exceeding the safe design speed is known as the:

25. Which of the percentage is likely to be achieved in three weeks’ time for a well-cured cement structure’s strength?

26. If the fluid particles move in a zig-zag way, the flow is called:

27. The width of land secured and preserved to the public for road purposes is called:

28. Which of the following is most accurate estimate?

29. The most critical stage of construction is construction of:

30. The enclosure where an aircraft is keep for maintenance and repair is known as

31. Which of the following is not a cross drainage work?

32. To measure discharge a……… pressure must be created in flow fluid:

33. “Water Bound Macadam” is one of the… types of payment:

34. Hydraulic Gradient Line (HGL) represents the sum of:

35. Chain surveying is used for small area in :

36. Granite comes under the category of:

37. In construction management the responsible of civil overseer is

38. Self-cleaning velocity is:

39. Contour lines run close together indicates:

40. The percentage of carbon in cast iron is:

41. Camber in the road is provided for :

42. By over reinforcing a beam, the moment of resistance can be increased not more than Camber in the road is provided for :

43. The type of bond provided in brick masonry for carrying heavy loads:

44. Sewerage system is designed for:

45. Depth of shallow tube well shall not be more than (considering economic point):

46. To prevent segregation, the maximum height for placing concrete is

47. The expansion joints are provided if the length of the concrete exceeds

48. Closed contours with higher value inside represents a

49. The shear resistance between particles is provided by …bonding at the points of contract

50. A balanced design of a beam is a condition where the …stresses occurring are equal to the permissible stress.