178

Sub-Engineer Mock Test of 50 Past Question #33

Sub-Engineer Collection of 50 Past Question from Loksewa Aayog Mock Test.

1 / 50

1. Bond strength of HYSD bar as compared to plain bar is more

2 / 50

2. The amount to publish for tender in national paper is:

3 / 50

3. Formwork suitable for construction work:

4 / 50

4. Tacheometer is best suited:

5 / 50

5. In plane table, instrument for horizontal & vertical measurement without chaining:

6 / 50

6. The chairman of material rate fixation committee in district is:

7 / 50

7. Work charge establishment:

8 / 50

8. Responsibility of overseer is to:

9 / 50

9. As per norms prepared by ministry of transport & works, one porter can carry a weight of……….in one day:

10 / 50

10. The amount of chlorine in supply during epidemic time:

11 / 50

11. For any crop, base period is measured in:

12 / 50

12. Optimum residual head at tap should be:

13 / 50

13. I m head is equivalent to:

14 / 50

14. At a horizontal curve the super elevation is provided to counteract

15 / 50

15. The main purpose of provide camber in a road is:

16 / 50

16. Perception and break reaction time depends up on:

17 / 50

17. Total lateral earth pressure is proportional to:

18 / 50

18. Hygroscopic water can be removed by:

19 / 50

19. Seal coat is mixture of:

20 / 50

20. According to manning’s  formula the velocity is inversely proportional to:

21 / 50

21. Allowable clay silt in sand for mortar is:

22 / 50

22. Best road suitable for pneumatic & iron wheeled vehicle is

23 / 50

23. Buckling occurs in a column:

24 / 50

24. Snowcem paint required for 100 m2 area as per norms (one coat)

25 / 50

25. Hardness of water can be removed by:

26 / 50

26. Portland pozzolana cement has strength as compared to ordinary Portland cement is:

27 / 50

27. In case of simply supported beam subjected to UDL, the maximum shear force occurs at a point:

28 / 50

28. Crest of weir is lower than d/s water level:

29 / 50

29. Maximum deflection of a simply supported beam subjected to concentrated load (w) at the mid-point is:

30 / 50

30. Bearing capacity of soil primarily depends upon:

31 / 50

31. Width of wall footing (according to thumb’s rule) is:

32 / 50

32. Capillary rise is proportional to:

33 / 50

33. Evaluation of building is done based on:

34 / 50

34. For maximum velocity occurring in a canal the hydraulic mean depth is

35 / 50

35. Measurement of railing of staircase:

36 / 50

36. Minimum width for stretcher bond:

37 / 50

37. According to Hook’s law which one is correct?

38 / 50

38. Q is the flow of a sedimentation tank in m³ per day, V is the volume of tank in m³ then find the detention period of tank:

39 / 50

39. Suitable aggregate is obtained from……….Rock:

40 / 50

40. Bench Mark is a point of known

41 / 50

41. Theodolite measures:

42 / 50

42. Seasoning of timber is done to:

43 / 50

43. 43. When water is added to cement, the cement hydrates and chemical reactions takes place while cement is setting an increase in temperature occurs and a considerable quantity of heat is generated is called:

44 / 50

44. Staff intercept means:

45 / 50

45. Singly reinforced beam & doubly reinforced beam are decided based on:

46 / 50

46. The sewer which receives discharge from house is called:

47 / 50

47. The structure on which arch rests is called:

48 / 50

48. The value shown in account book after allowing necessary depreciation:

49 / 50

49. Strength of tor steel as compared to mild steel is:

50 / 50

50. Reaction time for stopping a vehicle is:

Your score is

The average score is 68%

0%

Exit

Show CommentsClose Comments

Leave a comment