Sub-Engineer Mock Test of 50 Past Question #32

1. Pressure head is given by:

2. Bearing capacity of soil is determined by:

3. Depth of foundation is determined by:

4. Relation between void ratio (e) and porosity (n) is given by

5. Wetted perimeter of a channel is given by:

6. In a theodolite, staff reading for upper, middle and lower cross hairs are 1.4, 0.9 & 0.4 respectively. If the height of tower is100 m then find the horizontal distance between instrument station & base of the tower:

7. Find the compressive strength of concrete M25 under bending compression:

8. Minimum Length of transition curve in plain is:

9. Centrifugal force is given by:

10. The Bench Mark of a point is 400 m. Back sight reading at bench mark is 2.20 and fore sight reading of point A is 2.10 then find the RL of the point A:

11. Mostly the pipe used in Nepal for rural water supply scheme is:

12. The head of water representing in case of HGL line is known as:

13. The main constituent of cement in descending order is:

14. The width of carriageway of two lanes road width without raised curb is:

15. Drain in hill side road is provided:

16. Bending moment diagram of simply supported beam having uniformly distributed load is:

17. As per norms prepared by ministry of transport & work the number of manpower required to excavate one m3 of gravel soil:

18. The main constituent of varnish is:

19. An egg-shaped section of sewer:

20. Hauling of excavated soil is done by:

21. Diagonal crack is introduced in a beam due to:

22. Fixed delay is found in road due to:

23. Shear stress is not taken by:

24. Least bearing capacity of soil is:

25. Head loss in a pipe is inversely proportional to:

26. Brick wall could fail due to:

27. Impregnating of timber is done to increase:

28. Low porosity brick has:

29. The active earth pressure of a soil can be defined as lateral pressure exerted by the soil when:

30. According to WHO the amount of total solid in water should be

31. Contour interval of a map should be:

32. Contour crosses in case of:

33. Tender does not contain:

34. Cavity wall is designed for:

35. Which technique was used firstly for the planning of a project

36. Domestic water demand depends upon:

37. Plane table survey is considered good as compared to other survey since:

38. The maximum dry density occurs at a particular water content which is known as:

39. Sullage contains water from:

40. Hardness coefficient is maximum for

41. Mean velocity of canal should never be

42. Rubberisation temperature is:

43. Temporary structure to support the platform over which workman can sit and work:

44. Bleeding may be reduced by:

45. Traffic density depends upon the:

46. Turpentine is a:

47. A wooden block hinged on post outside a door, is known

48. As per ICAO, for airports serving big aircrafts, the crosswind component should not exceed

49. Water demand for Hospitals is ?

50. In analysis of rates, the profit and overhead for the contractor is generally taken as: